OpenCL Platform #1: NVIDIA Corporation
======================================
* Device #1: GeForce RTX 2070, 2048/8192 MB allocatable, 36MCU
Counted lines in testfile2.txt...Insufficient memory available
Insufficient memory available
Is this GPU not suitable for hashcat? i can switch it out for a 1080ti but would prefer to figure this one out
It's not the GPU that's out of memory most likely, its the host system. How much RAM does the host have? Also, for reference, how large is testfile2.txt?
what is your command ?
make sure that you do not confuse the hash file with the dictionary file.
If you specify the command line parameters in the wrong way, errors like the one you see could happen.
Code:
hashcat -a 0 -w 3 -O hash.txt dict.txt
you need to specify the hash file first !
(10-15-2019, 02:10 AM)Chick3nman Wrote: [ -> ]It's not the GPU that's out of memory most likely, its the host system. How much RAM does the host have? Also, for reference, how large is testfile2.txt?
The pc has 16gb of ram and the file is 4gb approx
C:\hashcat-5.1.0>hashcat32.exe -a 3 -m 0 hash.txt customlist.txt
hashcat (v5.1.0) starting...
* Device #1: WARNING! Kernel exec timeout is not disabled.
This may cause "CL_OUT_OF_RESOURCES" or related errors.
To disable the timeout, see:
https://hashcat.net/q/timeoutpatch
OpenCL Platform #1: NVIDIA Corporation
======================================
* Device #1: GeForce RTX 2070, 2048/8192 MB allocatable, 36MCU
Generated bitmap tables...Insufficient memory available
Insufficient memory available
Insufficient memory available
Insufficient memory available
new issue i have run into, any help appreciated
use -a 0 instead
the wrong one you used is not for dictionary attack (see --help output)
(10-16-2019, 10:35 AM)philsmd Wrote: [ -> ]use -a 0 instead
the wrong one you used is not for dictionary attack (see --help output)
when trying bruteforce i am met with insufficient memory after it tries to generate bitmap tables
Are you doing a brute force attack or a dictionary attack? Based on your initial post you are doing a dictionary attack using dict.txt, which means you need to use -a 0.
[ Attack Modes ] -
# | Mode
===+======
0 | Straight
1 | Combination
3 | Brute-force
6 | Hybrid Wordlist + Mask
7 | Hybrid Mask + Wordlist
(10-19-2019, 04:56 AM)slyexe Wrote: [ -> ]Are you doing a brute force attack or a dictionary attack? Based on your initial post you are doing a dictionary attack using dict.txt, which means you need to use -a 0.
[ Attack Modes ] -
# | Mode
===+======
0 | Straight
1 | Combination
3 | Brute-force
6 | Hybrid Wordlist + Mask
7 | Hybrid Mask + Wordlist
i have since switched to brute force -a 3